钼对马氏体不锈钢40Cr13Mo全氢罩式退火氧化皮的影响

潘红涛, 李照国, 张有余

冶金分析 ›› 2024, Vol. 44 ›› Issue (12) : 78-83.

冶金分析 ›› 2024, Vol. 44 ›› Issue (12) : 78-83. DOI: 10.13228/j.boyuan.issn1000-7571.012506

钼对马氏体不锈钢40Cr13Mo全氢罩式退火氧化皮的影响

  • 潘红涛1, 李照国2, 张有余1
作者信息 +

Effect of molybdenum on oxide scale of martensitic stainless steel 40Cr13Mo after full hydrogen batch annealing

  • PAN Hongtao1, LI Zhaoguo2, ZHANG Youyu1
Author information +
文章历史 +

摘要

本文对同种工艺生产的40Cr13Mo和40Cr13全氢罩式炉退火钢卷氧化皮样品进行了扫描电镜(SEM)、X射线能谱(EDS),以及X射线衍射(XRD)分析。结果表明:由于Mo的添加,40Cr13Mo不锈钢氧化皮较致密、剥落程度低,内部仅存在一些微小的缺陷,局部存在压应力且强度略高于氧化皮强度;与基体结合区域似胶状、且存在“楔形小凸起”钉扎深度0.81 μm的2FeO·SiO2(铁橄榄石);存在氧化皮厚度较小但极差较大,与基体结合面不平整的现象;EDS面扫描Cr元素能量分布趋势与O元素能量分布趋势一致,高能级区域占90%以上且分布在氧化皮的中层、里层,10%的中能级区域分布在氧化皮外围,不存在低能级区域,与基体结合区域Si呈连续中能级宽3 μm条带、条带上伴有3 μm高能级斑块;氧化皮被氢气还原的过程严重滞后,物相以FeCr2O4和FeO两相为主,两者的含量(质量分数,下同)之和达90.2%,Fe、Cr、Cr0.7Fe0.3三相的含量仅为9.6%。

Abstract

The oxide scale samples of full hydrogen batch annealing steel coil of 40Cr13Mo and 40Cr13 produced by the same process were analyzed by scanning electron microscopy (SEM), X-ray energy dispersion spectrum (EDS) and X-ray diffraction (XRD). The results showed that the oxide scale of stainless steel 40Cr13Mo was dense with low peeling degree due to the addition of Mo. Only few small defects were observed inside. There was pressure stress in some parts and the strength was slightly higher than that of oxide scale. The bonding regions with matrix were colloidal, and there were “small wedge prominences” of 2FeO·SiO2 (fayalite) with pinning depth of 0.81 μm. The oxide scale thickness was small but the range was large, and the bonding surface with matrix was uneven. The energy distribution trend of Cr was consistent with O in EDS surface scanning. The high-level regions accounted for above 90%, which were distributed in middle and lining of oxide scale. The middle-level regions of 10% were distributed in periphery of oxide scale, and there were no low-level regions. In the bonding regions with matrix, Si showed continuous middle-level stripes with width of 3 μm, and there were 3 μm high-level spots in stripes. The reduction process of oxide scale with hydrogen lagged behind seriously. The phases were mainly FeCr2O4 and FeO. Their contentsaccounted for 90.2% (mass fraction, the same above), and the contents of Fe, Cr and Cr0.7Fe0.3 were only 9.6%.

关键词

不锈钢40Cr13Mo / 不锈钢40Cr13 / / 全氢罩式退火 / 氧化皮 / 微观形貌 / 微观结构 / 物相

Key words

stainless steel 40Cr13Mo / stainless steel 40Cr13 / molybdenum / full hydrogen batch annealing / oxide scale / microtopography / microstructure / phase

引用本文

导出引用
潘红涛, 李照国, 张有余. 钼对马氏体不锈钢40Cr13Mo全氢罩式退火氧化皮的影响[J]. 冶金分析, 2024, 44(12): 78-83 https://doi.org/10.13228/j.boyuan.issn1000-7571.012506
PAN Hongtao, LI Zhaoguo, ZHANG Youyu. Effect of molybdenum on oxide scale of martensitic stainless steel 40Cr13Mo after full hydrogen batch annealing[J]. Metallurgical Analysis, 2024, 44(12): 78-83 https://doi.org/10.13228/j.boyuan.issn1000-7571.012506
中图分类号: O657    TG142.71   

参考文献

[1] 朱立.钢材酸洗技术[M].北京:化学工业出版社,2006:20-25.
[2] 王建泽,钱张信,惠恺,等.铁素体不锈钢罩式退火表面铬氧化物富积机理[J].金属热处理,2017,42(9):202-205.
WANG Jianze,QIAN Zhangxin,HUI Kai,et al.Cr2O3 enrichment on surface of ferritic stainless steel during batch annealing[J].Heat Treatment of Metals,2017,42(9):202-205.
[3] 潘红涛,张昭.Q235B热轧带钢氧化皮开卷易剥落原因分析[J].冶金分析,2023,43(3):91-96.
PAN Hongtao,ZHANG Zhao.Reason analysis on uncoiling and peeling of oxide scale of Q235B hot rolled strip[J].Metallurgical Analysis,2023,43(3):91-96.
[4] 王博,李铸铁,战东平.高氮耐候钢锈层的电化学与物相表征[J].冶金分析,2018,38(4):11-15.
WANG Bo,LI Zhutie,ZHAN Dongping.Electrochemical and phase characterization of rust layer on high nitrogen weathering steel[J].Metallurgical Analysis,2018,38(4):11-15.
[5] 黄希祜.钢铁冶金原理[M].北京:冶金工业出版社,1981:284-289.
[6] 吴园园,张珂,洪慧敏.硅钢高温氧化铁皮的显微结构表征[J].冶金分析,2014,34(10):25-31.
WU Yuanyuan,ZHANG Ke,HONG Huimin,et al.Characterization of the microstructure of high temperature oxide scale on silicon steel[J].Metallurgical Analysis,2014,34(10):25-31.
[7] 王为,陈复民,李国俊,等.新型超高强度马氏体时效不锈钢组织及性能[J].钢铁,1989,24(2):53-57.
WANG Wei,CHEN Fumin,LI Guojun,et al.Structures and properties of new ultra-high strength maraging stainless steels[J].Iron and Steel,1989,24(2):53-57.
[8] 姜越,尹钟大,朱景川,等.马氏体时效不锈钢的发展现状[J].特殊钢,2003,24(3):1-5.
JIANG Yue,YIN Zhongda,ZHU Jingchuan,et al.Development status of maraging stainless steel[J].Special Steel,2003,24(3):1-5.
[9] 李锋,孟帅捷.Cr13型马氏体热轧不锈钢退火酸洗生产探讨[J].四川冶金,2019,41(3):34-36.
LI Feng,MENG Shuaijie.Discussion on the annealing and pickling of Cr13 martensitic hot rolled stainless steel[J].Sichuan Metallurgy,2019,41(3):34-36.

18

Accesses

0

Citation

Detail

段落导航
相关文章

/