Determination of copper based on fluorescence switch of CdTe quantum dots-dithizone
YIN He-nan1, DAI Wei-jian2, ZHANG Si-bao3, GE Shen-guang2, LI Shuai2, YAN Mei2, HUANG Shi-feng*1
1.Shandong Provincial Key Laboratory of Preparation and Measurement of Building Materials, School of Material Science and Engineering, University of Jinan, Jinan 250022, China; 2.School of Chemistry and Chemical Engineering, University of Jinan, Jinan 250022, China; 3.Chemical Technology Academy of Shandong Province, Jinan 250014, China
Abstract：The surface of CdTe quantum dots was coated by dithizone. The fluorescence quenching of CdTe occurred due to fluorescence resonance energy transfer between dithizone and CdTe quantum dots. The fluorescence resonance energy transfer was prohibited due to the formation of bidentate chelate after copper ion was added,then the fluorescence intensity of CdTe quantum dot was recovered. Based on this, a new determination method of trace copper by fluorescent switch was established. Under the optimal conditions, copper ions of different concentration were added into the solution which was composed of 0.5 mL of dithizone @CdTe quantum dots (Dit@CdTe),1.5 mL of Tris-HCl buffer solution (pH 7.5). After standing for 10 min, the fluorescence intensity of solution was measured at 431 nm/591 nm (excitation wavelength/emission wavelength). The enhanced fluorescence intensity showed good linear relationship to Cu2+ concentration in the range of 0.01-10.0 μmol/L with correlation coefficient of 0.990 3. The detection limit was 0.004 μmol/L.The proposed method was applied to the determination of copper in actual water sample. The relative standard deviation was less than 6.8%, and the recovery was 97%-105%. The determination results were consistent with those obtained by inductively coupled plasma mass spectrometry (ICP-MS).
尹赫南,戴伟建,张思宝,葛慎光,李帅,颜梅,黄世峰. CdTe量子点-双硫腙荧光开关测定铜[J]. 冶金分析, 2013, 33(7): 21-24.
YIN He-nan, DAI Wei-jian, ZHANG Si-bao, GE Shen-guang, LI Shuai, YAN Mei, HUANG Shi-feng. Determination of copper based on fluorescence switch of CdTe quantum dots-dithizone. , 2013, 33(7): 21-24.
Wenrong Y, Edith C, Gary DW, et al. Exploring the use of the tripeptide Gly-Gly-His as a selective recognition element for the fabrication of electrochemical copper sensors [J]. Analyst, 2003, 128: 712-718.
[2]
Aristidis N A, Thalia M. Flow injection online solid phase extraction system using Oasis-HLBTM micro- cartridge forchromium(VI) and copper determination by flame atomic absorption spectrometry [J]. Anal. Methods, 2011, 3: 1392-1398.
[3]
刘建波, 张萍, 范广, 等. 微波消解样品-火焰原子吸收光谱法测定美白化妆品中铅和铜[J]. 理化检验-化学分册(Physical Testing and Chemical Analysis Part B:Chemical Analysis),2011, 47(5): 520-522.
沈丽. 催化分光光度法测定铜(Ⅱ)[J]. 光谱试验室(Chinese Journal of Spectroscopy Laboratory),2011, 28(2): 967-969.
[6]
Dube H, Ams M R, Rebek J. Supramolecular control of fluorescence through reversible encapsulation[J]. J. Am. Chem. Soc.,2010,132(29): 9984-9985.
[7]
Song D, Lim J M, Cho S, et al. A fluorescence turn-on H2O2 probe exhibits lysosome-localized fluorescence signals [J]. Chem. Commun., 2012, 48: 5449-5451.
[8]
Impellizzeri S, McCaughan B, Callan J F, et al. Photoinduced enhancement in the luminescence of hydrophilic quantum dots coated with photocleavable ligands [J]. J. Am. Chem. Soc.,2012,134(4): 2276-2283.
[9]
Henry E, Dif A, Schmutz M, et al. Crystallization of fluorescent quantum dots within a three-dimensional bio-organic template of actin filaments and lipid membranes [J]. Nano Lett.,2011,11(12): 5443-5448.
[10]
Zhang K., Mei Q S, Guan G J, et al. Correction to ligand replacement-induced fluorescence switch of quantum dots for ultrasensitive detection of organophosphorothioate pesticides[J]. Anal. Chem.,2012,84(2): 1193.
[11]
Ge S S, Zhang C C, Zhu Y N, et al. BSA activated CdTe quantum dot nanosensor for antimony ion detection [J]. Analyst, 2010, 135: 111-115.
