电感耦合等离子体原子发射光谱法测定碳化钼催化剂中钼

doi:10.13228/j.issn.1000-7571.2014.11.012

摘要
图/表
参考文献
相关文章 (15)

全文: PDF (723 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要研究了电感耦合等离子原子发射光谱法测定碳化钼催化剂中钼的测定条件包括溶样酸、仪器参数、分析线和干扰的消除等,在此基础上建立了碳化钼催化剂中钼的测定方法。样品用 HNO₃、HF、HClO₄的混酸溶解处理后,在体积分数为2.5%的硝酸和1%氢氟酸混酸介质中,以Mo 202.030{166} nm 作为分析谱线,采用电感耦合等离子原子发射光谱法测定。通过筛选分析谱线、合理设置背景扣除位置,避免了光谱干扰。方法应用于碳化钼催化剂样品中钼的测定,结果与重量法(GB 50591-85)一致,相对标准偏差(n=6)小于1.5%,回收率在99%～100%之间。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	李延超
	李来平
	张新
	刘燕

关键词 ：电感耦合等离子体原子发射光谱法(ICP-AES), 碳化钼催化剂, 钼

Abstract：The determination conditions of molybdenum in molybdenum carbide catalyst by inductively coupled plasma atomic emission spectrometry were studied, including the selection and dose of acid for sample dissolution, the selection of instrumental parameters and analysis lines, and the elimination of interference. On the basis of this, the determination method of molybdenum in molybdenum carbide catalyst was established. The sample was dissolved with mixed HNO₃, HF and HClO₄. Then, the content of molybdenum was determined in mixed acid medium (2.5 % (V/V) HCl + 1 % (V/V) HF) by inductively coupled plasma atomic emission spectrometry using Mo202.030{166} nm as analysis line. The spectral interference was eliminated by properly selecting analysis line and setting background deduction position. The detection limit of method was 0.05-3 mg/g. The proposed method was applied to the determination of molybdenum carbide catalyst samples. The found results were consistent with those obtained by gravimetric method (GB 50591-85). The relative standard deviation (RSD, n=6) was less than 1.5%. The recoveries were between 99% and 100%.

Key words： inductively coupled plasma atomic emission spectrometry (ICP-AES) molybdenum carbide catalyst molybdenum

收稿日期: 2013-12-24

ZTFLH:

O657.31

基金资助:陕西省科技计划项目(2012k07-24)

作者简介: 李延超(1983-),男,硕士,助理工程师,现从事有色金属材料分析;

引用本文:

李延超,李来平,张新,刘燕. 电感耦合等离子体原子发射光谱法测定碳化钼催化剂中钼[J]. 冶金分析, 2014, 34(11): 61-64. LI Yan-chao, LI Lai-ping, ZHANG Xin, LIU Yan. Determination of molybdenum in molybdenum carbide catalyst by inductively coupled plasma atomic emission spectrometry. , 2014, 34(11): 61-64.

链接本文:

http://47.93.29.245/Jweb_yjfx/CN/10.13228/j.issn.1000-7571.2014.11.012 或 http://47.93.29.245/Jweb_yjfx/CN/Y2014/V34/I11/61

[1]	Eklof S, Barese F G, Sarholz D. Crystalface specificity in ammonia synthesis on tungsten carbides[J]. Journal of Catalysis, 1976, 43(4): 353-355.
[2]	Ledoux M J, Huu C P, Chianell R R. Current opinion in solid state&material science [J]. Catalysis with Carbides, 1996, 1(5): 96-100.
[3]	庞德元. 氧化还原容量法测定钼[J]. 理化检验:化学分册(Physical Testing and Chemical Analysis:Part B Chemical Analysis), 1992, 28(6): 346-347.
[4]	白小叶. 氧化还原滴定法测定矿石中的钼[J]. 有色矿冶(Non-ferrous Mining and Metallurgy), 2007, 23(6): 58-61.
[5]	王隽. 硫氰酸盐差示光度法测定钼铁中钼[J]. 理化检验:化学分册(Physical Testing and Chemical Analysis:Part B Chemical Analysis),2001, 37(7): 331-337.
[6]	汤成兰,王兆存,刘景华. 硫氰酸盐分光光度法快速测定钼铁中钼[J]. 冶金分析(Metallurgical Analysis), 2007, 27(11): 78-79.
[7]	贾丽娟,钟宏,符剑刚. 溶液中钼的快速测定[J]. 稀有金属与硬质合金(Rare Metals and Cemented carbides), 2007, 35(3): 34-37.
[8]	王宝玲, 李小莉, 田文辉. 熔融制样-X射线荧光光谱法测定三氧化钼中7种组分[J]. 冶金分析(Metallurgical Analysis), 2011,31(1): 45-49.
[9]	李波,周恺,孙宝莲,等. X射线荧光光谱法测定钼铝合金中钼[J]. 冶金分析(Metallurgical Analysis), 2013,33(9):42-45.
[10]	陈金凤,黄焕斌,陈章捷,等. 电感耦合等离子体原子发射光谱法测定钨铁中砷、铜、猛、钼、磷、硅含量[J]. 冶金分析(Metallurgical Analysis), 2011,31(3): 42-45.
[11]	张宁. 电感耦合等离子体原子发射光谱法测定矿石中的钨钼[J]. 冶金分析(Metallurgical Analysis), 2010, 30(10): 25-28.